Reseller Zone Knowledgebase BroadbandConnect Connect a FortiGate to the NBN

Connect a FortiGate to the NBN

Print
nbn, router, pppoe 0

This guide connects a Fortinet FortiGate to our NBN service through the NBN box, using the WAN interface's PPPoE mode.

Updated 21 November 2026Applies to FortiGate routers

What you'll need

  • Your NBN username and password, from the welcome email we sent
  • A computer connected to the router by cable or Wi-Fi
  • The router's sign-in details, usually on a label underneath it

Your NBN settings

Connection typePPPoE
UsernameAs supplied, for example yourname@nbnconnect.net.au
PasswordAs supplied
IP addressGet it automatically. If your router has a field for a fixed IP address, enter the static IP address we supplied.
DNSAutomatic. If your router needs them entered: 103.5.90.253 and 103.5.91.253
MTU1492
VLANOff, for most businesses. If you use VLANs: VLAN ID 100, priority 0

Set up the FortiGate

  1. Set the WAN interface to PPPoE

    Go to Network > Interfaces, edit the WAN port and set Addressing mode to PPPoE. Enter the username and password, then select OK. Fortinet offers this in the web interface on its smaller models; on others, use the CLI commands below.

  2. DNS, only if needed

    Go to Network > DNS, set DNS Servers to Specify, enter the two addresses and select Apply.

  3. Or use the CLI

    Open the CLI console from the dashboard and use the commands under the VLAN tab that matches you. Replace wan1 with your WAN port's name.

VLAN

VLAN or no VLAN? If you're not sure, you don't need one: leave VLAN settings off. Use VLAN ID 100 only if your business uses VLANs, or the person who looks after your network asks for it.

No VLAN (most businesses)

config system interface
    edit "wan1"
        set mode pppoe
        set username "yourname@nbnconnect.net.au"
        set password "yourpassword"
    next
end

Using a VLAN

config system interface
    edit "nbn-vlan100"
        set vdom "root"
        set interface "wan1"
        set vlanid 100
        set role wan
        set mode pppoe
        set username "yourname@nbnconnect.net.au"
        set password "yourpassword"
    next
end

Update your firewall policies. With a VLAN, internet traffic leaves through nbn-vlan100, so your outgoing policy must use it in place of wan1.

Still not working?

  • Check the username is the whole address, including @nbnconnect.net.au, and retype the password.
  • If you turned on a VLAN, try again with it off (or the other way round).
  • Restart the NBN box and the router, then wait two minutes.
  • Still stuck? Open a ticket with your router's make and model, and a photo of the lights on the NBN box.

What's next

Steps follow Fortinet's FortiOS 7.6 administration guide (interface settings, interface MTU and DNS).

Was this guide helpful?

Still stuck?

Send us the details and our team will take it from here

Open a Support Ticket